Pedestal Poster Stand - Double Sided, 590 x 885 mm Insert, Black

A double sided pedestal stand for a foyer, a reception or a showroom floor. It stands 158.5 cm on a 450 x 325 mm base, with a black frame, a woodgrain-finish pole and a marble-look panel set into the base - it is built to look like part of the room rather than a piece of shop fitout.

The board slides down into the frame from the top and is read from both sides, so a single board printed on both faces does the work of two signs. Lifting it out and dropping the next one in is the whole process of changing the message.

The 635 x 900 mm figure you will see on the frame is its outside measurement, not the board size - the board sits inside that.

Questions & Answers

Q: What size should I have printed?
A: Make the board 585 x 880 mm. The slot takes up to 590 x 885 mm, so a little under that goes in and out easily without catching.

Q: Is a board included?
A: No. The stand takes a rigid board you supply - corflute up to 5 mm thick is the usual choice - cut to the size above. A paper poster on its own will not stand up in the slot; mount it on the board first.

Q: How does the board go in?
A: It slides down into the frame from the top and sits there under its own weight. Lift it out to change it.

Q: Is it double sided?
A: Yes - one board, read from both sides, so print both faces of it.

Q: Can the height be adjusted?
A: No. It stands at a fixed 158.5 cm.

Q: Can it go outside?
A: It is an indoor stand - foyers, receptions, showrooms, corridors.

More floor stands and pedestals are in poster stands and floor sign holders. For a poster on the wall instead, see our snap frames and poster displays.